|
|
Pro Equine No Turn Bell Boot
Pro Equine No Turn Bell Boot with Armortex (Kevlar)on back / Ballistic Nylon on sides. Wont tear or rip. Double Velcro tabs overlap in front of each boot. Tough layer of Kevlar reinforcement on the back side of the boot. Binding along the bottom edge of the boots is Kevlar material as well. Boots stay securely on and the tabs wont open until you want them to! Bound Edges are smooth and will not cause rubs. So much easier than struggling with rubber pull on boots- and they look great. Just toss them in the wash or rinse off in a bucket. Long wearing and tough enough for daily use but they clean up and look great for show days as well. ***NOTE*** As far as sizing goes, if you are not sure of the size its better to err by being on the larger side - boots can be a bit "floppy" and still do a great job of protecting the hoof and bulb area. If they are too small, they are more prone to rub, and to being torn off because the velcro wont have enough overlap to hold strongly, and they also wont have as good coverage of the areas that need covering! (bulb area, or the shoe itself - if you are trying to keep shoes from being torn off from overstride) You can use the same size guidelines as are shown for the simple splint boot - small size is for ponys - shoe size 000 to 0 - medium is for horses with smaller hooves - shoe size 0 to size 1 , Large is for bigger horses -- shoe size 2 to size 3 - and x large is for large horses, - shoe size 3 to size 4 ***These boots are sold as pairs, so you will receive 2 boots.***
|
